Editing File:ToddWessShuttleDiagram1.gif
Revision as of 20:18, 9 November 2008 by Yagni01 (talk | contribs) (The figure below shows dimensions and cutting pattern for parts L1, L2, R1, R2 and the base for C5, C6 & C7 to be cut from a piece of 48”x48” material. I used 1/8” plywood. When joining two pieces together, the joint was reinforced from below with �)
Warning: You are editing an out-of-date revision of this page. If you save it, any changes made since this revision will be lost.
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.