Editing File:ToddWessShuttleDiagram2.gif
Revision as of 20:21, 9 November 2008 by Yagni01 (talk | contribs) (The figure below shows the cutouts for panel C1 and C2 and the two pieces to make panel C3. I had to make C3 into two pieces so that I could fit all of the panels on 4 sheets of 48”x48” material. The other two pieces are the support panels for pane)
Warning: You are editing an out-of-date revision of this page. If you save it, any changes made since this revision will be lost.
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.